Prusa MK3S+ printing the calibration castle from
The clearance is perfect (I think) on the castle and the clearance test part using the Prusa printer, Prusa Slicer (with the settings Angus suggests) with only a small issue with the bridge arch.
The filament was PolyMaker's PolyTerra laba red with the appropriate profile loaded into Prusa Slicer.
I want to test more filaments as I've got a bit of a broad range on hand and I find with the exact same settings the results are very different (including needing to adjust the Z axis to get good bed adhesion), so if I find the time, I'll post a follow up to this video.
The clearance castle is at https://www.makersmuse.com/clearance-...