The Most Incompetent Guide to Installing Klipper
How to switch a 3D printer to Klipper firmware and do a lot of magic to set it up and print. I don't recommend using my guide, but it might help you understand the topic. At worst, you'll just have a laugh :)
----------------
⭐ Telegram channel (content is posted there more often) ⭐
https://t.me/marsovich20
✨ Boosty (financial support for the channel) ✨
https://boosty.to/marsovich20
For collaboration, contact us on any social media or by email.
----------------
Thanks to sponsors:
Maxim (Telegram)
Vyacheslav Litvinov (Boosty)
TrashRobotics (Boosty)
You can also become a sponsor :)
----------------
Music:
If you own the copyright to any of the music I used (including those not mentioned below) and do not allow the use of your music on YouTube, please contact me, and the video will be removed:
[email protected]
Barroom Ballet - Silent Film Light by Kevin MacLeod
DonPixel Sebas Gana Futaba - Good Bay
Quincas Moreira - Merengue de Limon
Back to 1981 — Iaio
Joe E. Lee - The Budapest Project
Dan Lebowitz - A Dusty Road
Top Ten - Jeremy Blake
Lawrence - TrackTribe
Jules Gaia - Glitz At The Ritz
Kevin MacLeod - Run Amok
Huey Daze - Cherry
Bad Piggies Main Theme
Megalovania
TheFatRat - Unity. Official video: • TheFatRat - Unity
TheFatRat, JJD - Prelude. Official video: • TheFatRat & JJD - Prelude (VIP Edit)
TheFatRat - The Calling (feat. Laura Brehm) Official video: • TheFatRat - The Calling (feat. Laura Brehm)
----------------
#3dprint #3dprinter #clipper