How to use speakers in Proteus Simulator
Tishitu explains
A transducer is a device that converts a signal in one form of energy to another form of energy.
Energy types include (but are not limited to) electrical, mechanical,
electromagnetic (including light), chemical, acoustic or thermal energy.
While the term transducer commonly implies the use of a sensor/detector,
any device which converts energy can be considered a transducer.
We are talking about acoustic transducer i.e. speakers
A speaker is an electroacoustic transducer that
produces sound in response to an electrical audio signal input.
Most speakers use two wiring points to connect to the source of the signal
(for example, to the audio amplifier or receiver).
This is usually done using binding posts or spring clips on the back of the enclosure.
Our simulation tool is proteus.
Proteus is software for microprocessor simulation, schematic capture,
and printed circuit board (PCB) design.
It is developed by Labcenter Electronics.
We are showing you how to connect proteus with your computer sound card.
The input signal is shown in the digital oscilloscope.
A potentiometer is use here as volume controller as it is used to adjust input signal amplitude or voltage.
TISHITU
ISO: 9001-2008
RESEARCH AND CONSULTANCY CELL OF INDUSTRIAL APPLICATION
A Joint Accreditation System of Australia and New Zealand
Copyright © All Rights Reserved www.tishitu.org Reg No.08122629691/SSI
Accreditation No. M3111204IN
~-~~-~~~-~~-~
Please watch: "Lifi Communication by Arduino UNO Download Project"
• Lifi Communication by Arduino UNO Download...
~-~~-~~~-~~-~