prusa mk2s MMU xyz calibration problem
After updating the 3d printer to the new firmware 3.1.0 it does not work anymore.the printer cannot find the bed leveling points in the 2nd and 3d row anymore. the platform moves to far in y-direction.about 12mm to far in the second row and even more in the third row. The printer workes before. the tape is there to mark the location of the bed calibration points in the video. x-direction movement is o.k. the pinda probe was turned down more than usual to prevent damage of the printbed and to exclude the problem it might be to far away from the bed.
IMPORANT NOTE: i used MESH BED LEVELING TO ILLUSTRATE THE PROBLEM BECAUSE IT IS FASTER. BUT IS IT THE SAME PROBLEM WITH XYZ CALLIBRATION WHICH I DID BEFORE!