Peak Detection Using Sample and Hold Block in MATLAB Simulink #37 | Basics | INFO4EEE
In this video, a logic is created to detect the peak of the sinusoidal signal using a sample and hold block in MATLAB Simulink.
0:00 Intro
0:30 MATLAB Simulink model for peak detection
3:09 Outro
Recommended :
👉Sample and Hold Block in MATLAB Simulink #36 - • Sample and Hold Block in MATLAB Simul...
👉Single Phase Waveform Using MATLAB Simulink #02 - • Single Phase Waveform Using MATLAB Si...
******************
Dr. Paramjeet Singh Jamwal (#PSJamwal) working as a Temporary Faculty in the Electrical Engineering Department at the National Institute of Technology (NIT), Hamirpur, Himachal Pradesh, India since September 2023. To learn more about Dr. Jamwal click on the following link to his Profile 👉https://bit.ly/2TxTPsQ
******************
INFO4EEE (#Info4eee) stands for Information for Electrical and Electronics Engineering and was founded in 2012. To learn more about INFO4EEE click on the following link 👉https://bit.ly/3jG6tR3
#MatlabWithPSJamwal #matlabtutorial #Matlab #Simulink