2.9.1 Packet Tracer - Basic Switch and End Device Configuration
CCNAv7 - Introduction to Network (ITN)
Cisco CCNA1 Packet Tracer. Netacad, IT network.
Objectives:
Configure hostnames and IP addresses on two Cisco Internetwork Operating System (IOS) switches using the command-line interface (CLI).
Use Cisco IOS commands to specify or limit access to the device configurations.
Use IOS commands to save the running configuration.
Configure two host devices with IP addresses.
Verify connectivity between the two PC end devices.
Scenario:
As a recently hired LAN technician, your network manager has asked you to demonstrate your ability to configure a small LAN. Your tasks include configuring initial settings on two switches using the Cisco IOS and configuring IP address parameters on host devices to provide end-to-end connectivity. You are to use two switches and two hosts/PCs on a cabled and powered network.