Making A Raspberry Pi Home Assistant Hub Using The Atomstack X20 Pro
In this video, I'm going to use the new Atomstack X20 Pro laser cutter to make a Home Assistant hub to control my smart home devices. The X20 Pro uses a clever quad laser design to achieve 20W of optical cutting power, a first for a consumer-level diode laser.
Thanks to Atomstack for providing the X20 Pro for this project, check out their online store through the links below.
ADDITIONAL INFORMATION
---------------------------------------------------
Visit my blog for the written build & CAD files - https://www.the-diy-life.com/i-made-a...
Get the Atomstack X20 Pro - https://bit.ly/3zXLJwz
Smart Home Solver's channel - / smarthomesolver
How to Design a Case in Inkscape - • How To Design A Pi Case For Laser Cut...
PURCHASE LINKS
---------------------------------------------------
Raspberry Pi 4B - https://amzn.to/3xJXtQA
32GB Sandisk Ultra MicroSD Card - https://amzn.to/3Qe6ObL
Aluminium Heatsink - https://amzn.to/3QGCYwD
Conbee II Zigbee Gateway - https://amzn.to/3QDFPq5
M3x8mm Button Head Screws - https://amzn.to/3NOTQPT
M3 Nuts - https://amzn.to/3NOTQPT
M2.5 Brass Standoffs - https://amzn.to/3zUkRgT
M2.5 Nuts - https://amzn.to/3zUkRgT
M2.5 Screws - https://amzn.to/3zUkRgT
Equipment Used:
Atomstack X20 Pro - https://bit.ly/3zXLJwz
Electric Screwdriver - https://amzn.to/3aOeDVa
Milwaukee Oscillating Multitool - https://amzn.to/3ba0VvY
Some of the above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, at no additional cost to you.
CHAPTERS
---------------------------------------------------
0:00 Intro
0:55 Unboxing & Setup of the X20 Pro
4:25 Test Cut & Engraving
5:25 Designing the Home Assistant Hub
6:05 Laser Cutting the Housing
7:45 Assembling the Housing
8:45 Using the Atomstack App
9:12 Installing the Hub Components
11:35 Zigbee Gateway
12:44 Boot up & Using the Hub
14:05 Final Thoughts
If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.