Raspberry Pi 400 Tips + Teardown: GPIO, Pi400 Setup, SSD Boot, Battery +more
In this video we'll take a very close look at the new Pi 400, so close we'll even open it up and take a peek inside. We'll also discuss a number of different ways you might want to use your Pi 400 and give you a quick glance of some new things coming to the channel. *NOTE: The Python program shown in this video may also be found below, if you want to avoid re-typing it.
Dec 2020 PiOS Update blog entry: https://www.raspberrypi.org/blog/new-...
PiOS Official SSD Instructions for USB Mas Storage on a Pi 400: https://www.raspberrypi.org/documenta...
Items Shown in this video
=====================
Pi 400 Computer Kit: https://www.canakit.com/raspberry-pi-...
Pi 400 (Only): https://www.canakit.com/raspberry-pi-...
Super Starter Kit for Raspberry Pi 4 B 3 B+ 400 (Cobbler / GPIO Expansion) : https://amzn.to/2JVBWQ1
Lepow 15.6 Inch Full HD 1080P USB Type-C Portable Display: https://amzn.to/3kMS6aW (My Video review of this monitor is here: • Lepow 15.6" IPS Portable Monitor Setup / H... ) - I use it for everything!
EAFU Portable Charger/10000mAh LED Display with, Dual 3A High Speed Outputs: https://amzn.to/34dTSMs
Coiled Micro HDMI to Mini HDMI Cable: https://amzn.to/34byDLa
USB 3.0 SATA III Hard Drive Adapter Cable: https://amzn.to/2WeUWeT
Kingston 240GB A400 SATA 3 2.5" Internal SSD SA400S37: https://amzn.to/3gPpBc2 (Don't know how other SSD drives will compare/perform, only own this one)
As an Amazon Associate I earn from qualifying purchases.
Chapters
00:00 - Introduction
01:27 - Pi 400 Teardown
03:04 - GPIO Interface
04:19 - Run Pi 400 on Powerbank
05:58 - Latest Pi OS Updates
06:55 - Pi OS Imager and SSD Install
10:12 - Retro Game Controllers
11:42 - Conclusion
** Python Program used in this video (Thonny IDE) **
-- ( Copy the Following ) --
import RPi.GPIO as GPIO
import time
ledPin1 = 21
GPIO.setmode(GPIO.BCM)
GPIO.setup(ledPin1, GPIO.OUT)
GPIO.output(ledPin1, GPIO.HIGH)
time.sleep(1)
GPIO.output(ledPin1, GPIO.LOW)
time.sleep(.5)
GPIO.output(ledPin1, GPIO.HIGH)
time.sleep(1)
GPIO.output(ledPin1, GPIO.LOW)
GPIO.cleanup()
-- (Don't copy beyond here) --
If you found this video helpful/informative, please ...
**** Like / Share and Subscribe ****
→→ http://wagnerstechtalk.com ←←
SUBSCRIBE for the latest TechTalk: https://www.youtube.com/wagnerstechta...
----------------------------------------------------------------------------------------------------------------------
Feel free to ask us a question in the comments below or visit our website, we try to answer most questions that we can.
Email: [email protected]
Website: http://wagnerstechtalk.com
Or join us on one of the following social media sites...
Facebook: / wagnerstechtalk
Twitter: / wagnerstechtalk
#RASPBERRYPI #PI400 #WTT #RETROPIE #RASPBERRYPI400