How to fix common problem of multimeter
In this video i shown a continuity problem in MAS830L multimeter. This type of problem caused by while checking high voltages and the high spike voltage causes some fault in the PCB, in my case a R17(122 code) resistor is burned so I replace with 1.2K resistor and the whole problem is solved.
Top Playlists -
1). • Diy
2). • Bread Board
Plz Subscribe my channel -
/ innovationic
My Best Videos -
• Hall Effect Sensor A3144 hall sensor #hall...
• The Uses of 49E Linear Hall Sensors
• 4 Channel Transmitter-Receiver HT12E & HT1...
• Top 3 Circuits With LM358
• Unbelievable Trick to Easily Repair Your B...
• How to make led driver circuit at home | 1...
• UC3845 Boost Converter(200W)
• Flyback Converter
• SG3525 + LM358 PWM Controller for Inverter...
• XL6009 Boost Converter Upgrade
• Buck-Boost / MPPT Controller
• Multimeter Upgrade !
• Home made 2-Channel IR Receiver | Innovati...
• Uncover the Secret Behind the TTP223 Touch...
• How To Make Over Load Protection For Inver...
• Over Voltage Protection Using LM358/LM393
• LED & Zener Diode Tester
• How to make 4 Channel 433MHz TX-RX
• UC3843 Buck Boost Converter
• Top 5 Innovation With LM393 | fire sensor ...
• Laser Data Transmitter
• Making 50000 RPM BLDC MOTOR
• Instant Heating Solder Iron
• Amezing Protection Circuit
• 2 in 1 Circuit using just 13005 transistor
• XL6009 Current Control Upgrade #lm358 #xl6...
• How Brushless Motor Works ? Drone Motor BL...
• 12V Relay Protection Circuit
Plz Do LIKE
SHARE
SUBSCRIBE
TO this channel INNOVATION IC
#innovation
#multimeter
#mas830l
best fluke multimeter,how to repair multimeter,how to fix continuity problem in multimeter,cheap yellow multimeter upgrade,mas830,mas830l,best multimeter upgrades,how to work with multimeter