How to connect dstv extraview using diplexers |
How to connect dstv extraview using diplexers | #diy
#dstv #satellite #extraview To install DStv ExtraView, you will need the following components:
Two DStv decoders: You will need two DStv decoders to enable ExtraView. One decoder will serve as the primary or main decoder, while the other will be the secondary decoder.
A DStv Smart LNB: The Smart LNB is a special type of LNB (Low Noise Block) that supports ExtraView. It allows for communication between the primary and secondary decoders.
You can also use a dual LNB
A DStv Multiswitch: The Multiswitch is used to split the signals from the Smart LNB to the primary and secondary decoders. It ensures that both decoders receive the necessary signals.
Here are the steps to install DStv ExtraView:
Ensure you have a satellite dish installed and properly aligned to receive the DStv signal.
Connect the Smart LNB to the satellite dish using a coaxial cable. Make sure the connections are secure.
Connect the Smart LNB to the Multiswitch using another coaxial cable. Again, ensure the connections are tight.
Connect the primary decoder to the Multiswitch using a third coaxial cable. Use the output labeled "Unicable" or "SCR" on the Multiswitch.
Connect the secondary decoder to the Multiswitch using a fourth coaxial cable. Use another available output on the Multiswitch.
Power on both decoders and the TV.
On the primary decoder, go to the settings menu and navigate to "DStv ExtraView Setup" or a similar option. Follow the on-screen prompts to initiate the ExtraView setup process.
During the setup process, you will be asked to enter the DStv Smartcard number of the secondary decoder. Ensure you have the correct Smartcard number for the secondary decoder and enter it when prompted.
Once the setup is complete, the primary decoder will be able to control the secondary decoder, and you can access DStv channels on both decoders simultaneously.
Repeat the setup process on the secondary decoder, following the on-screen prompts and entering the Smartcard number of the primary decoder when prompted.
After completing the setup on the secondary decoder, you should have a fully functional DStv ExtraView system.
It's worth noting that the exact steps and menu options may vary slightly depending on the specific model of the decoders and the version of the DStv software. It's recommended to consult the user manual or contact DStv customer support for assistance if you encounter any difficulties during the installation process.
https://ccijtechub.blogspot.com/2023/...