ESP32 Dev | ESP IDF VSCode extension | Part 1: Install and configure the ESP IDF VSCode extension
A comprehensive beginner’s guide to the setting up and configuration of the ESP-IDF extension for VSCode.
Once set up, you will be able to build, flash and monitor your running ESP32 device using the extension.
This video assumes that you have do not have the Espressif ESP-IDF framework installed.
I also assume that you have already installed the USD to UART bridge driver.
See my video
• ESP32 Development | Getting started with E...
for installation details.
Find Part 2 of this series here
• ESP32 Dev | ESP IDF VSCode extension | Par...
• VSCode for ESP32 Development
------------------------------------
Chapters
00:00 Introduction
00:11 Aims
00:25 Prerequisites
01:32 Install the ESP-IDF VSCode extension
02:06 Configure the extension
04:28 View example projects
04:58 Copy blink project example
05:36 Customise the blick project
06:14 Pre-build extension configuration
07:06 Build the example project
07:32 Flash the example project to the ESP32 device
07:48 Monitor the running ESP32 device
08:04 Extension status bar icon summary
------------------------------------
I will post content covering aspects of programming and developing using the ESP32 single board computer every week.
If you have some topics that you’d like us to cover, then please describe them in the comments below.
------------------------------------
Did you like this video?
Why not buy me a coffee?🍵https://buymeacoffee.com/cerrotec
Full source code and circuit designs on on Patreon / cerroteclabs
------------------------------------
I offer software engineering and ESP32 consultancy services.
If you’d like to hire me for your next project, please email me at [email protected]