How to Display AFR ERROR Using HP Tuners VCM Suite 3.X Software
0:10 In the 3.X scanner, Histograms are called Graphs.
0:22 If you already have our Learn at home course: http://www.thetuningschool.com/produc...
0:30 Follow the steps in our guide that show you how to create a MAF AFR Error Historgram
0:50 How to setup up MAF AFR Error Histogram so it works every time using 3.0 VCM suite
1:14 Before we begin we have to make sure we are recording a couple of essential parameters
1:25 Wideband setup video • How to Set Up Your Wideband Inside of HP T...
1:30 You'll need to add AFR Commanded and...
1:50 How to add ARF Commanded
2:10 How to add Mass Air Flow Frequency
2:20 Great new feature on 3.0 Search feature great for saving time.
2:50 Hard way to add...
3:10 Add new Graph...
3:50 Maths Section
4:10 You can see by adding this it also named it for us
4:20 Cell hits required Set to 5 for part throttle tuning, but leave at 0 if doing Wide open throttle tuning
4:30 Define Column Axis
5:00 Generic Sensor Tip
6:00 We will need the tune file of the vehicle we are tuning
6:20 Pull up tune file from our VCM Editor
6:25 How to find Mass Air Flow Frequency
6:35 High vs low
7:00 Now we've showed you how to define how your graph is displayed in HP Tuners VCM Suite 3.0
7:20 Time to do some WOT testing
For more High-Performance Tuning Knowledge #HPTK
Check out our website: http://thetuningschool.com/newtuners/
Be sure to follow us on
Facebook: / thetuningschool
Instagram: / thetuningschool