KT200/KTM200 Read and Write BMW MSV90 in Boot Mode
KT200/KTM200 Read and Write BMW MSV90 in Boot Mode
#Machenic #Garage #CarRepair
Copyright Disclaimer under section 107 of the Copyright Act 1976, allowance is made for “fair use” for purposes such as criticism, comment, news reporting, teaching, scholarship, education and research.
Fair use is a use permitted by copyright statute that might otherwise be infringing.
Non-profit, educational or personal use tips the balance in favor of fair use.
Update Launch X431 Scanner https://launchx431-pro3.blogspot.com/...
Buy Launch X431 Car Diagnostic Tool https://launchx431-pro3.blogspot.com/
Today we are going to read and write BMW MSV90 ECU with KT200/KTM200 ecu programmer in boot mode. First of all, open KT200 software, click on Manual
Then search MSV90 instruction wiring diagram ‘ KT200 MSV90 Boot Pinout Now we need to connect the ECU with the KT200 follow the wiring diagram click to select driver and tool boot select the ecu module and click on ok
Tool Boot-Infineon tricore boot- SAK TC1796 click connect and wait for the connection established create a new folder on the desktop
now we are ready to start reading the data in the ecu
then click read all to select the save path and save it to the newly created folder on the desktop
please wait patiently until the data is read completely
save the ecu data read by kt 200 ecu programmer in the newly created folder Then connect a new MSV90 DME follow the diagram
Select write in flash micro and write eeprom separately Attention:
please select write in flash micro, eprom and write your modified ecu data separately.
and wait patiently for the writing to complete Checksum is corrected. KT200 ecu programmer Write MSV90 ECU succeeded.