Samsung Galaxy J6 Charging Problem Solution | Samsung J600F Not Charging Ways Jumper Repair
In this video, we explain the Samsung J6 Charging Problem Solution step by step. If your Samsung J600F is not charging, charging slowly, charging only when cable is pressed, moisture detected, or no charging symbol issue, this guide covers charging connector ways, charging IC, USB tracks, filters, and jumper solutions. Full Urdu Hindi tutorial for mobile hardware repair engineers.
🔧 30 Step-by-Step Instructions
Power off Samsung J6 completely.
Remove SIM tray and back cover.
Disconnect and remove the battery.
Unscrew and open the charging board shield.
Inspect charging connector physically.
Clean charging port with IPA and brush.
If pins are damaged, replace charging connector.
Resolder charging connector properly.
Check for loose/broken pads under port.
Test charging again with original cable.
If still no charging, check VBUS line continuity.
Measure 5V at charging connector input.
Trace 5V line to charging filter.
Replace charging filter if open.
Check ground connection continuity.
Inspect charging fuse for open circuit.
Replace fuse if faulty.
Trace VBUS to charging IC.
Measure voltage at charging IC input.
If missing, jumper directly from connector.
Check output of charging IC.
Replace charging IC if no output.
Inspect battery connector pins.
Clean and resolder battery connector.
Check battery connector voltage (3.8–4.2V).
Replace battery if faulty or not charging.
Test USB data lines for shorts.
Jumper broken charging tracks.
Reassemble phone and connect charger.
Confirm phone charges normally and battery percentage increases.
📢 Hashtags
#SamsungJ6 #SamsungJ600F #SamsungChargingProblem #SamsungNotCharging #SamsungRepair #SamsungChargingSolution #ChargingIC #USBConnectorProblem #MobileRepair #SamsungHardwareSolution