GRAVITY HACK! Complete 3D Mode Guide (EN subs)
🌀 This mode breaks physics by turning the drone into a helicopter! Now it can fly upside down.
I figured it out and I'm sharing with you:
✅ How to activate 3D flight in Betaflight
✅ How to properly configure the ESC and not burn out the motors
✅ How to safely test the mode on the table and in flight
✅ What blades are needed and life hacks with their installation
💡 This is not just a feature - it's a new style of flight that will open up other facets of FPV for you.
Little things, but facts:
✅ Standard blades with a higher pitch behave better when inverted
✅ The first flights in 3D are best done with a camera tilt angle of 0° - this makes it easier to navigate the horizon. Later, you can select the angle to your taste: different tilts allow you to perform different 3D maneuvers.
https://app.betaflight.com/
https://esc-configurator.com/
https://am32.ca/
https://github.com/bitdump/BLHeli/rel...
Timecodes:
0:00 What is 3D mode
0:31 How it works
0:58 Importance of simulator
1:33 What is desync
1:53 What to do before setup
2:11 Bluejay and BLHeli_S setup
2:30 About Bluejay versions
3:08 Continuing with Bluejay and BLHeli_S setup
3:51 BLHeli_32 setup
4:59 AM32 setup
6:02 Betaflight setup
7:29 Optional Airmode disabling
8:20 Checking motor rotation
8:59 How to arm
9:20 Desktop test of 3D mode for desyncs
9:33 About 3D blades
10:18 Lifehack for flying with standard blades
10:51 3D blade tests
14:06 GPS and 3D
14:25 How to remove 3D
14:33 How to deal with desyncs
15:06 The importance of setting the 3D throttle dead zone
15:48 The uselessness of Brake on Stop
16:30 Additional information
16:55 3D flight from the side
IG: / spiniksfpv
TikTok: / spiniksfpv
#3DMODE #Betaflight #FPV