Anycubic Kobra Max Screen UI 3rd party update
Anycubic Kobra Max Screen UI 3rd party update #3dprinting #3d #3dprinter #anycubic #kobramax
Anycubic Kobra Max UI dark screen update using a 3rd party developer file
here is the link to the github website for this firmware, it provides a simple step by step guide.. ensure to follow this exactly as described.
3DPUK channel is not responsible for any issues following this update and is souly the users responsibility to ensure they follow guide correctly and could potentially devalidate your warranty
thanks again too jojos38 and wabbitguy for bringing this to the community 🙏
please see links below
https://github.com/wabbitguy/anycubic...
follow the guide
don't forget to like and subscribe 😉
Installing the modded UI firmware
Download and unzip.
Unzip the DWIN_SET folder at the root of your SD card (make sure to use a reliable SD card, the one shipped with the printer is not), do not put anything else but this folder, if you had the old folder from the official firmware, remove it before
Turn off your printer put the SD card under the screen, not in the printer the body. Make sure to leave it unplugged for 10 - 20 seconds to make sure the caps can discharge
Turn on your printer and wait until you see SD card Process... END ! on the second line, do NOT turn off the printer before this line appears. The process shoudn't take more than 5 minutes unless your SD card is broken or very slow
Make sure the number next to .BIN Files shows 003 and the number next to .ICL Files 001
Turn off your printer, remove the SD card
Done, you can turn it on