G-Code Basics
Hi!
In this video, I'll teach you the basics of G-Codes in the field of 3D-printing with some very easy and understandable examples.
Thru this video I hope to motivate more people to do some easy G-Codes by themselves because it's not complicated at all.
G-Code for determining the build-plate center: https://pastebin.com/Q9VKPe3M
FYI: I set my build-plate volume to 200x200mm in Cura.
RepRap Wiki about G-Code: http://reprap.org/wiki/G-code
Expect an upgrade video next week.
A detailed list of all active upgrades can be found below, as well as a link to my 3D-printing playlist.
If you have any questions, or feedback on how I can improve, feel free to leave it in the comments section below!
Enjoy the video!
-----------------------------------------------------------------------------------------------------------
This video is part of my 3D-printing playlist: • 3D-Printing
About my Technologies:
3D-Printer: Anet A8 (original)
Ordered from: https://www.3dprintersbay.com/
Upgrades:
Semi-Circular Fan Duct: http://www.thingiverse.com/thing:1954001
Y-Belt Tensioner: http://www.thingiverse.com/thing:1959208
X-Belt Holder: http://www.thingiverse.com/thing:1666094
T-Bracket (frame stabilization): http://www.thingiverse.com/thing:1672959
E3D-v6 carriage: http://www.thingiverse.com/thing:2099577
Bowden motor bracket: http://www.thingiverse.com/thing:2146021
Camera + Microphone: Oneplus One, OBS studio, the t.bone SC450
Editing Software: kdenlive for Windows