How to solder polypropylene pipes | temperature, setting time and other subtleties ...
give Leha money (cripto)
trc20 usdt: TNJ7HVRLJTTjXdDgx4B1Z7eTw9ngQNub5E
erc20 eth:
0xada5467a12b1ce597b709d0a93aabd5720ce463a
btc: 1Q3owuiTh65W3TFKqERbnwC29xErun2GBy
Polypropylene pipes of 20, 25 and 32 diameters are soldered at a temperature of 260-270 degrees.
We take a pipe and mark about 12 mm from the edge, we need this mark so as not to crush the pipe and not to solder the hole through which water flows.
I am right-handed, so it is more convenient for me to hold a pipe going into space in my left hand, and a fitting in my right hand.
I chose the right hand for the fitting, because the fitting is very easy to solder at the wrong angle, and the right hand is easier to control all these processes.
After soldering the fitting, do not immediately release it, you need to hold it for an average of 6 seconds.
All these are approximate values, because in practice everything is different and depends on the air temperature in the room, the soldering iron and your mood. So just try it.
Hope you enjoyed this short video.
Watch other videos on the channel. I will be glad to likes and comments.
inst
/ lexa.rad
main channel
/ dramabums
/ dramabums
#dalyubvi #plumbing #plumbing #polypropylene pipes