MQ3 Sensor Interfacing with PIC16F628A | Simulation |Alcohol, Benzine, Hexane,LPG,CO Gas Detector
-----------------------------------------------------------------------------------------------------------------------------------------------------------------
-------------------------
Features of MQ-3 Alcohol Sensor
-------------------------
1] Sensor Type - Semiconductor
2] Easy SIP header interface
3] Compatible with most of the microcontrollers
4] Low-power standby mode
5] Requires heater voltage
6] Good sensitivity to alcohol gas
7] Fast response and High sensitivity
8] Long life and low cost
9] Requires simple Drive circuit
---------------------
Specifications of MQ-3 Gas Sensor
---------------------
1] Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off)
2] Current Consumption: 150mA
3] DO output: TTL digital 0 and 1 ( 0.1 and 5V)
4] AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
5] Detecting Concentration: 0.05-10mg/L Alcohol
6] nterface: 1 TTL compatible input (HSW), 1 TTL compatible output (ALR)
7] Heater consumption: less than 750mW
8] Operating temperature: 14 to 122 °F (-10 to 50°C)
9] Load resistance: 200kΩ
10] Sensitivity S: Rs(in air)/Rs(0.4mg/L Alcohol)≥5
--------------------------
Tune with us on
---------------------------
🏷️Facebook : / electronicsdeveloper
🏷️Instagram : / electronics_developer
🏷️Tweeter : https://twitter.com/Electronics_Dev?s=09
🏷️LinkedIn : / electronics-with-shreyash
🏷️Pinterest : / electronics_developer
------------------------------------------------------------------------------------------------------------------------------------------------------------------
On this Channel we Upload Conceptual parts of Embedded systems in which Sensors, Modules, Transducer etc interfacing as a subpart of mega projects if you like this content or You want a help to do projects similar to that tutorial content, comment your Email Address I will share necessary documents which helps you.
Thank you !