Change Boot Cisco Access Point AIR-AP1852I-S-K9 (% Authentication failed No valid user found, ....)
To download part1, you must:
1) (RNAQ-C7)# printshenv
BAUDRATE=9600
BOOT=part2
ENABLE_BREAK=1
FACTORY_RESET=0
MANUAL_BOOT=0
MEMORY_DEBUG=0
2) (RNAQ-C7)# setshenv BOOT part1
3) (RNAQ-C7)# printshenv
BAUDRATE=9600
BOOT=part1
ENABLE_BREAK=1
FACTORY_RESET=0
MANUAL_BOOT=0
MEMORY_DEBUG=0
4) (RNAQ-C7)# saveshenv
Writing to SPI Flash... done
5) (RNAQ-C7)# boot
Specified BOOT: part1
Booting from part1
Read 1024 bytes from volume part1 to 45000000
Read 52495854 bytes from volume part1 to 45000000
Signature returns 0
Image signing verification success, continue to run...
Using machid 0x1260 from environment
Starting image ...
.....
Only
.......
[*07/31[ OK ] Started AP Trace daemon.
Starting AP Trace daemon...
Starting capwapd...
[ OK ] Started Hostapd process.
Starting Hostapd process...
[ OK ] Started Fast CGI daemon.
Starting Fast CGI daemon...
Starting Cisco led service...
[ OK ] Started Slow CGI daemon.
[ OK ] Started Cisco led service.
[ OK ] Started Dropbear (SSH) server.
User Access Verification
Username/Password: Cisco/Cisco
You've got no choice but to reboot the WLC using CLI. The command to forcefully reboot the WLC is "reset system forced".
Lightweight AP disable console logging
command " logging console disable"
Resetting an Aironet 1852i
command "capwap ap erase all "
Part 1✅ : Convert Cisco AIR-AP1852I-S-K9 to Mobility Express, %Authentication failed
No valid user found please configure a valid user from Controller
Video: 👉 • Convert Cisco AIR-AP1852I-S-K9 to Mob...
Part 2✅ : Convert Cisco AIR-AP1852I-S-K9 from Mobility Express to Lightweight ( CAPWAP MODE) (Use Controller )
Video: 👉 • Convert Cisco AIR-AP1852I-S-K9 from M...
Contact :
+Telegram group: https://t.me/CCNP300_410
Facebook: / 100010133917307
Youtube: / @exploitoperate