Connect Two Networks Using Cisco Router | IPv4 & IPv6 Configuration Tutorial | CCNA Lab 12 (200-301)
🚀 In this CCNA 200-301 Lab 12 tutorial, learn how to connect two networks using a Cisco router with both IPv4 and IPv6 configuration. This step-by-step lab is perfect for beginners and those preparing for the CCNA certification.
🔧 What You'll Learn in This Lab:
How to configure interfaces on Cisco routers
How to assign IPv4 and IPv6 addresses
How to enable routing between two networks
Troubleshooting basic network connectivity issues
📽️ Previous Lab11: • IPv6 Auto Configuration in Cisco Packet Tr...
📽️ Next Lab13: • Configure DHCP Server for Multiple Network...
For any assistance WhatsApp: +918078212814
📌 Follow Me for More CCNA Content:
🔗 / @techacad
🌐 Website: http://techacadhelp.com/
📘 Facebook: / techacad4u
📸 Instagram: / techacadhelp
📺 Watch the full playlist here: • Free CCNAv7 Packet Tracer Labs for beginne...
0:00 Introduction
00:32 Design the Topology
02:41 Design Addressing Table
15:55 Basic Settings on CISCO Devices
17:28 Configure Router interfaces with IPv4 and IPv6 Address
20:07 Enable IPv6 Unicast-Routing
20:50 Configure Management interface(SVI) on CISCO Switch
23:05 Verify the configuration using show commands
24:07 Configure the End Devices with IPv4 and IPv6 Address
29:20 Test End-to-End Connectivity
• Like • Comment • Subscribe for more free CCNA labs and tutorials!
#Cisco #CCNA #IPv4 #IPv6 #Networking #CiscoRouter #CCNALabs #NetworkTutorial #CiscoConfiguration #CCNA200301