10 Steps to Solve Bed Adhesion and Warping on Your Bambu Lab A1
Hi everyone!
Ever since I purchased my Bambu Lab A1, I have had issues getting my prints to stick to the build plate. My corners were lifting, my prints were getting ruined from poor adhesion, and honestly, it was super frustrating. After a lot of time researching, experimenting, and failing, I found 10 tips to get perfect bed adhesion on your 3D printer.
-------------------------------------------------------------------------------------------------------------------------------------------------------
If you are new to 3D printing, enjoyed this video, want to support the channel, AND pick up some great beginner tools for your workshop, consider checking out the links below! They support me at no cost to you.
3D printing Tool Kit - https://amzn.to/4mp4z5J
Digital Dial Calipers - https://amzn.to/4cxz1r3
Fanttik Rotary Tool - https://amzn.to/4mp4z5J
Black Filament - https://amzn.to/4tfl6M4
-------------------------------------------------------------------------------------------------------------------------------------------------------
If you have any additional suggestions, comments, or questions, feel free to leave them down below!
Here is the link to the filament dryer that I use, if you are interested. I do NOT gain any commission from this link.
https://www.amazon.com/dp/B09HJL95RH?...
00:00 - Welcome!
00:30 - Tip 1: Clean your build plate
00:55 - Tip 2: Preventing drafts
01:16 - Tip 3: Dry your filament
02:05 - Tip 4: Adjust nozzle temp
03:05 - Tip 5: Adjust bed temp
03:33 - Tip 6: No cooling for 3 layers
04:00 - Tip 7: Adjust fan speed
04:27 - Tip 8: Turn off force cooling
05:13 - Tip 9: Different Build Plate
06:05 - Tip 10: Run auto-leveling
06:31 - Thank you!
How to improve bed adhesion
How to fix 3d printer bed adhesion
Bambu Lab bed adhesion issues
Bambu lab 3d prints not sticking
3D prints not sticking to the build plate
My 3d prints arent sticking
Song: Slowly
Composer: Tokyo Music Walker
Website: / @tokyomusicwalker4038
License: Creative Commons (BY 3.0) https://creativecommons.org/licenses/...
Music powered by BreakingCopyright: https://breakingcopyright.com
#3dprinter #diy #3dprinting