ESP32 Development | Set up the ESP-IDF VSCode extension with the ESP-IDF Development Framework
A comprehensive beginner’s guide to the setting up and configuration of the ESP-IDF extension for VSCode with with the Espressif ESP-IDF framework.
Once set up, you will be able to build, flash and monitor your running ESP32 device using the extension.
This video assumes that you have already configured your Espressif ESP-IDF framework in VSCode, and that you have installed the USD to UART bridge driver. See my video
• ESP32 Development | Getting started with E...
for details.
• VSCode for ESP32 Development
------------------------------------
Chapters
00:00 Introduction
01:02 Check command line build
01:54 Install ESP-IDF extension
02:37 Trial build from extension
02:51 Configure user settings
04:39 Manual build
04:58 Build failure from the ESP-IDF extension status bar
05:10 Select the ESP-IDF framework
05:51 Build using the ESP-IDF extension status bar
06:14 Flash the device from the ESP-IDF extension status bar
06:30 Monitor the ESP32 device execution
------------------------------------
I will post content covering aspects of programming and developing using the ESP32 single board computer every week.
If you have some topics that you’d like us to cover, then please describe them in the comments below.
------------------------------------
Did you like this video?
Why not buy me a coffee?🍵https://buymeacoffee.com/cerrotec
Full source code and circuit designs on on Patreon / cerroteclabs
------------------------------------
I offer software engineering and ESP32 consultancy services.
If you’d like to hire me for your next project, please email me at [email protected]