GeoTools Tutorials: Set out-of-range elevation values to nearest valid elevation values
In this video we are going to cover GT_SET_Z_PL Commands in GeoTools For AutoCAD, BricsCAD, ZWCAD and ARES Commander Software.
*******************************
Video Description:
GT_SET_Z_PL
Often, you may have polylines in which some vertices have a zero [0.0] elevation while others have non-zero elevations. This command sets the Z values of those zero elevation vertices to the nearest non-zero vertex elevation value. The command scans through the polyline and seeks a non-zero value nearest to it and assigns it to the vertex. Thus, at the end of the command run, there will not be any polyline vertices, which are of 0.0 elevation. Therefore, this command is best used when you are sure that there should not be any vertex of elevation = 0.0 anywhere along the polyline.
*******************************
CADPower Tutorials | CADPower Videos for AutoCAD BricsCAD ZWCAD ARES Commander | DesignSense Software Technologies | Rakesh Rao
https://bit.ly/3yZpJ0y
GeoTools Tutorials | GeoTools Videos for AutoCAD BricsCAD ZWCAD ARES Commander | DesignSense Software Technologies | Rakesh Rao
https://bit.ly/2U6z3ku
All Videos | GeoTools & CADPower Tutorials | DesignSense Software Technologies | Rakesh Rao | AutoCAD | BricsCAD | ZWCAD | ARES Commander
https://bit.ly/3r8TVU6
Please don’t forget to Subscribe | Like | Share our Channel:
https://bit.ly/2UXrvAx
Contact us at:
DesignSense Software Technologies Pvt. Ltd.
365/8, “Hasmitha Avenue”, First Floor
16th Main Road, Jayanagar 4T Block,
Bengaluru – 560 041, India.
Web: https://www.thedesignsense.com
Email: [email protected]
Contact: +91-9243438300
Thank You
#geotools #cadpower #designsense