Find Underground cable fault Using Arduino | Simulation
Detect underground cable fault using Arduino | how to detect underground cable fault | simulation in proteus software |
----------------------------------------------------------------------------------------------------------------------------------------------------------------
-------------------------
📌Tags
--------------------------
#cablefault #simulation #diy
-------------------------
📌Testing and results
-------------------------
Circuit can be tested with different resistor values to simulate various fault conditions. It displays exact location of short circuit. Similarly you can find the open circuit in a cable using capacitance measurement technique.
--------------------------
📌What we learn?
--------------------------
1. What are the different cable faults?
2. How to detect cable faults?
3. How to detect fault location?
4. How to measure small value resistance?
--------------------------
📌Different Cable Fault
--------------------------
There are main two faults in cable short circuit and open circuit.
🧧Short Circuit Fault
Short circuit can be determined by measuring resistance between two cables at one end (base station). The value of resistance tells us the exact location of short circuit.
🧧Open Circuit Fault
Open Circuit can be detected by measuring the capacitance between two wires. Capacitance of cable changes according to the length. The length of cable varies based on the location of cable cut (open). As the cable is open parallel wire capacitance gets reduced based on this we can calculate the fault location.
The proposed system is to find the exact location of the fault. The project uses the standard concept of Ohms law i.e., when a low DC voltage is applied at the feeder end through a Cable lines, then current would vary depending upon the location of fault in the cable. In case there is a short circuit (Line to Ground), the voltage across series resistors changes accordingly, which is then fed to inbuilt ADC of Arduino board to develop precise digital data for display in kilometers.
The project is assembled with a set of resistors representing cable length in KM’s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same. The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the Arduino board. Further this project enhanced by measuring capacitance of cable which can even locate the open circuited cable.
-------------------------
📌Fault Detection
------------------------
The circuit is consists of 4 line display, arduino and resistance measurement circuit. Main component of the underground cable fault detection circuit is low value resistance measurement. It is constructed using a constant current source of 100mAmps. It can measure very low value resistance as the cables have around 0.01 Ohm/meter resistance. For 10meter cable resistance becomes 0.1 Ohm. This circuit can measure resistance up 50 Ohm, Maximum cable length it can check up to 25000 meters.
📌 Tune with us so you never miss any update
-------------------------------------------------------------------------------------------------------------------------------------------------------------
🏷️Telegram : https://t.me/electronicsdeveloper
🏷️Facebook : / electronicsdeveloper
🏷️Instagram : / electronics_developer
🏷️Tweeter : https://twitter.com/Electronics_Dev?s=09
🏷️LinkedIn : / electronics-with-shreyash
🏷️Pinterest : / electronics_developer