Extruder Calibration Cura
I created a video to calibrate the E steps on 3d printers using Cura on my Anycubic Kobra Go. Just thought it might be helpful for anyone that doesn't want to use Pronterface. I tried to keep it simple, let me know what you think.
Some PLA filaments that I've used
Overture Amazon Affiliate link https://amzn.to/3RWCOng
Eryone Amazon Affiliate link https://amzn.to/3La2YyV
Below is the code to copy & paste into Notepad++ then save as filename.gcode
Remember anything following ; is purely a note, not executable code.
/ @mayhemsmiley
;FLAVOR:Marlin
;Generated with Cura_SteamEngine 5.2.1
M92 E95.00 ; after testing you will change 95 to your test result value
M104 S200 ; set hot end temp
M105 ; report temp
M109 S200 ; wait for hot end temp
M82 ;absolute extrusion mode
G92 E0 ; Reset Extruder
G28 ; Home all axes
G1 E100 F100
M84 X Y Z ;Disable all steppers but E
M104 S0 ; switch off hot end
;End of Gcode