[BIONOTE] Vcheck V200: Automatic Software Update using LAN Cable
Update the Vcheck V200 software using LAN cable.
The whole procedure takes less than 5 minutes.
Please check if the LAN cable is well connected to the internet before undergoing the software update.
[Using LAN cable for an Automatic Software Update]
1. (0:05) Insert the LAN cable into the internet port, which is located at the side of the analyzer.
2. (0:10) Check if the S/W version is R018.16. Then click [Supervisor] on the Vcheck main screen.
3. (0:20) Enter the password and click [OK] (Initial password is 0000).
4. (0:25) Click [Settings]. On the "Settings" menu, click [General Settings], and then [Network].
5. (0:33) Click the circle button for [Wired], then click [Set Wired]
6. (0:37) On the "Local Area Network" sub-menu, click the circle button for [DHCP] and click [OK].
7. (0:42) Wait for the screen to display back the "Network" menu. Click [SET].
8. (0:48) Wait for the screen to display back the "General Settings" menu. Click [LIS Parameters].
9. (0:53) From the [Online Update Server], select [Web]. Then click [SET].
10. (1:04) You will be automatically returned to the "General Settings" menu.
Check for the E mark at the bottom left corner of the screen.
11. (1:09) Click [Back] twice, each from the "General Settings" and "Settings" menu.
12. (1:13) Click [Info.] from the "Supervisor" menu.
13. (1:17:) Click [View Network] to check if the IP/Gateway has been successfully set.
[Automatic Software Update Confirmation]
1. (1:20) Turn on or restart the V200 analyzer using the power button.
2. (1:30) Please check for the software update notice. Click [OK] to update.
Update notice will only be displayed if required.
3. (1:34) Click [OK] to restart the V200 analyzer to complete the software update.
4. (1:48) Check if the S/W has been successfully updated to the latest version.
Music: https://www.bensound.com
#Bionote #Vcheck #V200