Eliminate Ringing at 10,000 mm Acceleration with Input shaping?
I'm in the process of tuning a 350mm Voron 2.4 for speed and quality. The printer is controlled by a RPI4, Fysetic Spider, Klipper and Fluid. In this video I show the results both before and after including the results of manual tuning Input Shaping. I resort to a ADXL345 accelerometer. Check to see the results of this adjustment. This will work for any coreXY printer and with slight modification will work with other types as well. Was it worth the effort?
An earlier version of this video was removed from this channel when helpful viewers let me know there were severe audio problems. It took a week to resolve due to a video editor bug, but this should be correct. Thank you too all who let me know!
All parts and documentation are linked to below.
STL File for the ADXL345 accelerometer mount for the afterburner print head: https://www.thingiverse.com/thing:491...
These can be purchased at Amazon where I earn a commission that is directly applied to new content creation for this channel:
The ADXL345 accelerometer: https://amzn.to/3NiQU0J
The Ribbon Cable if you don't have the needed parts to make your own: https://amzn.to/40MVd7w
Klipper documentation for measuring resonances including wiring: https://www.klipper3d.org/Measuring_R...
Klipper documentation for manual input shaping: https://www.klipper3d.org/Resonance_C...
Spider MCU Diagram: https://github.com/FYSETC/FYSETC-SPID...