Milling on the Lathe
►Subscribe! https://bit.ly/2m1d1y7
►T-shirts & Hoodies! https://bit.ly/2kABytm
Recently I purchaced from ebay a dremel holder that can be attached to the toolpost of a lathe. The problem was that the shank was too thick for my lathe, and as a result the center of the lathe's chuck, wasn't at the same height as the dremel's chuck was. One way, was to sand it down to the desired thickness, but then I remembered that I had an 8mm end mill cutter that could do the job on my lathe. I did it twice because I had to flip it over to take the other half of the shank as you will see on the video.
Support my videos!: / johnnyq90
Subscribe to my channel! / johnnyq90
Follow me on Twitter! / johnnyq90
Follow me on Google+ https://plus.google.com/u/0/b/1046338...