Iemca Mini Boss 332 Magazine Bar Loader m/c 261123
Visit us at www.automatics.com
General Specifications per Brochure:
Bar Size Capacity
Mini Boss 332/12: 3mm (.118") - 32mm (1.259")
Bar Length Capacity: 12'
Maximum Bar Length: 12' 4"
Minimum Bar Length: 39"
Magazine Capacity: 11 linear inches
Maximum Remnant Length: 15.75"
Operating Voltage: 230V AC 3 Phase (400V available)
Control Voltage: 24 Volts DC
Total Power Required: 2.5 kVA/2kW
Compressed Air Required: 90 psi, 10 cfm
Guide Channel Oil: ISO 100, quantity 15 gals. (not incl.)
Feeding Speed: 30"/sec Max. (adjustable)
Facing Accuracy: +/- .020"
Bar Change Time: 27 seconds for 12' bar
Bar Straightness Required: .007"/foot
Bar Feeder Shipping Weight: 1750 lbs.
Color: RAL 5002 Blue, RAL 7035 Light Gray
Standard Equipment Includes:
Custom Electrical Cable Package & Interface Kit,
Remnant Retract, Synchronization Device, Bushing Device
Guide Channel Set includes
1 bar pusher, 1 nose, 1 rotating tip, 1 split bushing,1 collet
Options (Prices Subject to Change without notice)
PACKAGE A
Bar Feeder with two (2) complete guide channel sets which
includes 2 bar pushers, 2 rotating tips, 2 collets, 2 noses, 2 split
bushings and 1 spindle liner
Mini Boss 332/12 Package A: ................ $ 33,950.00
PACKAGE B
Bar Feeder with three (3) complete guide channel sets which
includes 3 bar pushers, 3 rotating tips, 3 collets, 3 noses, 3 split
bushings and 2 spindle liners
Mini Boss 332/12 Package B: ................ $ 35,720.00
Additional Spindle Liner: $ 360.00
Additional Telescopic Nose Reducer: $ 200.00
Additional Collets: $ 55.00
Additional Split Bushing: $ 75.00
Collets For Tube (Pipe) Up To 25mm ID: $ 90.00
Collets For Tube (Pipe) Frm 25.1 To 45mm ID $ 100.00
Axial Shift Device: $ 1,875.00
IEMCA Accessory Box: $ 920.00
IEMCA/Bucci USA Installation, Net Cost: $ 2,900.00
Includes labor, travel expenses and 12 month warranty
Important Notes:
Bar Feeder installation does not include lathe-side software or hardware for
magazine bar feeder interface. This interface must be supplied and installed
by the lathe OEM or Distributor, prior to bar feeder installation. Maximum
Bar diameters are for front ejection of the remnant. For remnant retraction,
maximum diameters are slightly less. Bar straightness, proper guide channel
selection, correct alignment and anchoring of bar feeder will ensure optimum
performance at maximum rpm.