picotouch slidercase demo
A simple 3d-printable protective enclosure for the PicoTouch USB MIDI / HID controller board. The result is still very thin (about 6mm) and helps prevent false triggers or bad calibration if touching the back on power up.
Prints in two pieces, no supports required. Snap the top piece around the PicoTouch board, then slide the combo into the bottom piece. A third “picocap” can be printed and glued to the top piece to protect the Pico, if desired.
Get a PicoTouch board: https://www.tindie.com/products/todbo...
Design files for 3d enclosure: https://www.printables.com/model/4253...
#picotouch #raspberrypipico #circuitpython #midicontroller