Cisco Show Interfaces Command | show ip interface brief command
Cisco Show Interfaces Command | show ip interface brief command
The "show interface brief" command is commonly used in network administration and is typically used on network devices like routers and switches to display a summary of information about the interfaces on the device. The exact syntax and output of this command can vary depending on the specific device and its operating system. However, the basic purpose is to provide a quick overview of the interfaces, including their status and IP addresses.
💻 Command: show interface brief 💻
This command would typically display a table with columns for Interface, IP Address, Status, and Protocol. Here's a general idea of what the output might look like:
Interface IP Address Status Protocol
-----------------------------------------------------
GigabitEthernet0/0 192.168.1.1 up up
GigabitEthernet0/1 192.168.1.2 up up
Serial0/0/0 unassigned down down
Serial0/0/1 10.0.0.1 up up
This command can also be carried out in a shorter form as
💻 Command: sh ip int br 💻
Note: Both commands carry out the same operation and must be used in Privilege mode on a Cisco router.