ESP32 Development | Getting started with ESP-IDF in VSCode
This video offers a step-by-step beginner’s guide to getting started with ESP32 development using VSCode.
In this video I will show you:
• how to configure VSCode for ESP-IDF
• how to install the USB to UART bridge which is essential for flashing your code to the ESP32 device
• how to build your first project and how to flash the ESP32 device
• VSCode for ESP32 Development
-----------------------------------
Chapters
00:00 Introduction
00:30 Install the ESP-IDF framework
04:11 Navigate installed ESP-IDF framework folders
06:25 Install VSCode
08:42 Install VSCode ESP-IDF extension
09:21 Configure VSCode command line parameters
11:17 Trial build the example app
11:54 Install USB to UART bridge driver
13:37 Build the example app for flashing to the ESP32 device
14:39 Flash the ESP32 device
------------------------------------
I will post content covering aspects of programming and developing using the ESP32 single board computer every week.
If you have some topics that you’d like us to cover, then please describe them in the comments below.
------------------------------------
Did you like this video?
Why not buy me a coffee?🍵https://buymeacoffee.com/cerrotec
Full source code and circuit designs on on Patreon / cerroteclabs
------------------------------------
I offer software engineering and ESP32 consultancy services.
If you’d like to hire me for your next project, please email me at [email protected]