Custom 3D-Printed 5-Inch FPV Drone - Full Build Walkthrough (No-Talking-Just-Building)
My Custom 3D-Printed 5-Inch FPV Drone - Full Build Walkthrough. "No-Talking-Just-Building"
STL files available on Vixen Printz Thangs (link in Bio).
Frame is available for both 20 x 20 and 30 x 30 stack mounting options.
For 30 x 30 stack builds, use different stack components (from the ones listed below) accordingly.
The following has been excluded from this walkthrough:
Betaflight Configurator Setup (Filters, PIDS, GPS, Motor Direction, FC Orientation, etc.)
DJI O3 FPV Camera to Goggles Binding
ELRS to Radio Reciever Binding
Let me know in the comments if you'd like me to cover the above excluded details.
If there's enough interest, I'd be happy to create a series of walkthrough videos to dive deeper into those topics.
Parts List:
Flight Controller - Mamba 4th Gen MK4 F722 Mini
Electronic Speed Controller - FOXEER REAPER SLIM 60A ESC
Receiver - Foxeer ELRS 2.4G Receiver LNA V3.2.1
Battery - Tattu R-Line 6S - 1200 mAh Lipo Battery XT60
Motor - 4 x T Motor F60 PRO IV 2.0 1950 kv
Propellor - 4 x HQ Prop Ethix S5
FPV Camera - Dji O3 w/ Stubby Antenna
GPS - MATEKSYS SAM-M8Q
Action Camera - Dji Action 2 w/ ND Filter
Frame - 3D Printed PET-CF (Bottom Frame w/ Upper Saddle)
Mounts - Transparent TPU (Motor Skids, Action Camera, FPV Camera, FPV VTX, ELRS RX)
Other
Screws (Stack, Motors, FPV Camera, Action Camera, Standoffs)
Standoff - 25mm M3 Smooth Hex
Racewire - 4 x RGB RACELITEWIRE
Music from Uppbeat (free for Creators!):
https://uppbeat.io/t/color-parade/lux...
License code: ZFVB7LDNMRKB94B9