Thermal Analysis in SOLIDWORKS Flow Simulation with Natural Convection
Learn how to setup an external analysis natural convection problem in SOLIDWORKS Flow Simulation. In this video we will setup an external analysis with heat conduction in solids, heat sources, solid material, size the computational domain, set up goals, and interpret the results as well as clone the project to test a design variation in an alternate configuration.
Download the files used in the video here: https://www.dropbox.com/sh/zu7tcrh3yv...
Presented by Ryan Navarro
Meshing Guide for Flow Simulation:
• Meshing guide for SOLIDWORKS Flow Simulation
Liquid Cooling in SOLIDWORKS Flow Simulation Webinar (larger assembly shown in this video)
• Designing Liquid Cooled Components with SO...
Setting up an Internal Analysis:
• Internal Pipe Flow with SOLIDWORKS Flow Si...
0:00 Introduction
0:45 Geometry Setup
1:52 Getting Started / Project Wizard
3:37 Sizing the Computational Domain
4:50 Solid Material definition
5:24 Heat Source definition
6:40 Mesh settings - Minimum gap size
7:00 Run the analysis
8:03 Interpreting results - Surface plot temperature, cut plot streamlines
9:10 Cloning project for alternate configuration
10:05 Interpreting second set of results - Flow trajectories
For more information on SOLIDWORKS: https://hawkridgesys.com/solidworks
For more information on SOLIDWORKS Simulation: https://hawkridgesys.com/solidworks/s...
Technical Support Knowledgebase: https://support.hawkridgesys.com/