ATA PTX4 Programming Instructions
Buy remotes here: http://bit.ly/ptx4-remote
Instructions:
Storing A New Remote
1. Press and hold the blue Door Code button on the motor or
SW1 or SW2 on the receiver board.
2. Press the new remote button you would like to use to control
the door for two seconds.
3. Release and pause for two seconds. Press the same button
again for two seconds.
4. Release the Door Code or SW button.
5. Press the remote button to test operation of the door/gate
etc.
Note: To remove a transmitter’s code from the device repeat
steps 1-5 above
Deleting All Remotes From Motor Memory
1. Turn the power off to the motor.
2. Press and hold Door Code or SW1 button.
3. Turn the power on again, while holding the button. The
Coding LED will illuminate to indicate that the receivers
memory has been deleted.
4. Release the button. All the stored codes including the
courtesy light codes should now be deleted. Confirm this by
pressing the transmitters previously used to operate the device.
There should be no response.