RIPv2 configuration and verification in GNS3 by Devendra Pratap Singh | CCNA 200-301|Network Creator
In this scenario, there are 3 router (R1, R2 and R3) and 3 LAN.
On router R1, R2 and R3, in the global configuration mode, enter the router rip command to enable RIP. In the RIP configuration mode, change the version of the protocol to 2 by using the version 2 command. Next, use the network command to include the self connected interface on the router R1, R2 and R3 in the routing process. Once you enable routing the verify routing table and protocol. One is most important in this video which is troubleshooting command.
IPv6 static routing configuration in GNS3: • IPv6 static routing configuration in GNS3 ...
Static routing configuration : • Static routing configuration in GNS3 || Ba...
GNS3 Installation: • GNS3 installation and configuration full s...
Static routing: • Static routing by Devendra Pratap Singh ||...
Routing introduction: • Routing Introduction by Devendra Pratap SI...
VLSM Class C : • VLSM C Class by Devendra Pratap Singh || N...
VLSM Class B : • VLSM Class B by Devendra Pratap Singh || C...
FLSM class C Part 1: • FLSM C-Class 50 hosts Part1 in Hindi by D...
FLSM Class B Part2: • FLSM Class A Part 3 explained step by step...
FLSM Class A Part3 : • FLSM Class A Part 3 explained step by step...
Subnetting Part1: • Subnetting Part 2 in Hindi by Devendra Pra...
Subetting Part2 : • Subnetting Part 2 in Hindi by Devendra Pra...
Subnetting Part3: • Subnetting Part 3 in Hindi by Devendra Pra...
Subnetting Part4: • Subnetting Part 4 in Hindi by Devendra Pra...
IPv4 Addressing Part2: • IP Addressing in easiest way - Hindi (Part...
IPv4 Addressing Part3 : • IP Addressing in easiest way - Hindi (Part...
IPv4 Addressing Part1: • IP Addressing in easiest way -Hindi (Part ...
BGP introduction : • BGP Introduction in Hindi By Devendra Prat...
BGP authentication : • BGP Authentication configuration in GNS3 b...
Email id : [email protected]