GNS3 LAN/WAN - How to enable Routing InterVlan with Cisco Switch layer step by step ‐ Part2
GNS3 How to enable Routing with Cisco Switch layer3 step by step
Introduction
Welcome to my page which goal is to help you to grow up skills security network IT
Objectifs : Mise en route d'une architecture LAN/WAN with Layer Cisco Switch
Steps :
1/Design of network architecture
2/Set up Switch
Start device and create Vlan1, VLAN10 and Vlan20
Assign IP address to vlans
Assign interface port to vlans
Enable routing on switch with cmd ip routing
3/TEST
Make a ping from PC1 to PC2 or PC2 to PC1 to establish connectivity between both PC
all your constructive comments are welcome
You can reach me at [email protected]
#cisco #routing #Intervlan #layer3 #networkit