How to design Sensor in Proteus and Arduino
This simulation is ultrasonic sensor interfacing to the arduino in proteus software measurement in the cm.
with 16*2 display also
Arduino code:
#include "LiquidCrystal.h" //lcd libary
LiquidCrystal lcd(2, 3, 4, 5, 6, 7); //LCD object Parameters: (rs, enable, d4, d5, d6, d7)
const int trigPin = 12; //trig pin connection
const int echoPin = 11; //echopin connection
long duration;
int distanceCm;
float liquid;
void setup() { // setup perameter
lcd.begin(16,2);
pinMode(trigPin, OUTPUT);
pinMode(echoPin, INPUT);
lcd.setCursor(0,0);
lcd.print(" Distance ");
lcd.setCursor(0,1);
lcd.print(" Measurement ");
delay(2000);
lcd.clear();
lcd.setCursor(0,0);
lcd.print(" Made By ");
lcd.setCursor(0,1);
lcd.print(" Jeet.org ");
delay(2000);
lcd.clear();
}
void loop() { // loop of flow program
digitalWrite(trigPin, LOW);
delayMicroseconds(2);
digitalWrite(trigPin, HIGH);
delayMicroseconds(10);
digitalWrite(trigPin, LOW);
duration = pulseIn(echoPin, HIGH);
distanceCm= duration*0.034/2;
lcd.setCursor(0,0);
lcd.print("Distance Measur.");
delay(10);
lcd.setCursor(0,1);
lcd.print("Distance:");
lcd.print(distanceCm);
lcd.print(" Cm ");
delay(10);
}