Motorcycle Cases "Version 2.0" are the best cases for DIY enduro travel.
Introducing the tested panniers for enduro travel.
Analysis of identified shortcomings, modernization and manufacturing.
Review, comparison of aluminum and textile wardrobe trunks.
Pros and cons of soft and hard bike cases.
#motorcycle #preparation #motorcycle
Canister 25l. https://clck.ru/ehwFw
Nylon belt tape 25,30,50mm https://aliclick.shop/r/c/1r9ofq73kqz...
Fastexes 50mm-4pcs, 30mm-8pcs, 25mm-4pcs
Double slotted buckle 6pcs https://aliclick.shop/r/c/1r9og881jsv...
PVC fabric https://clck.ru/ehwTT
Glue for PVC of the Russian company Clayberg, you can buy it where they sell PVC boats or even in a fishing store.
Double-sided adhesive tape https://aliclick.shop/r/c/1r9ogmba7ra...
Manufacturing
1. First, we cut off the top of the canister while leaving a bend so that there are stiffening ribs and it holds.
2. Now the valve of the hermetic bag. Cut PVC 35cm per meter. We stick adhesive tape on the canister, wrap it in PVC and glue the seam. We cut off a tape 25 mm wide, 70 cm long and cut off a 25 mm long shackle from the pvc of the resulting valve, sew the tape to the PVC and glue it to the airtight bag.
3. We cut the vertical belts 160 cm, take a 30 mm tape for handles 13 cm long and a segment 15 cm which we fold in half and sew in the middle of the first segment and sew the fastex here along with the handles. then we measure 53 cm from the fastex loop and make two 5 cm cuts with a hot knife indented from the edge of 5-7 mm. We cut off the tape for a tactical belt 40 cm long and, placing a pencil, sew it in increments of about 5 cm or at your discretion.
4. We cut off the horizontal belts 115 cm and sew on a double-slit buckle, measure 27 cm and make cuts 5 cm each, then measure 42.5 and also make cuts 5 cm. cut off the belt 30mm wide, 16cm long, thread the fastex and sew on so that the belt loop on the fastex is about 1.5cm from the end of the slot.
5. We cut the longitudinal belt 116cm, measure 2cm from the edge, make 5cm cuts, measure 14cm and make a 5cm cut, repeat on the other side of the belt. We take a 16 cm piece of a 25 mm belt and sew fastex 3-4 cm below the upper slot.
6. We cut off the harnesses for fastening through the seat with a length of 60 cm and sew a contact tape to it in the common people with Velcro, 25 cm long
7. Fastening to the frames cut off a tape 30 mm wide, 55 cm long for the lower and 47 cm for the upper ones and sew the upper fastening to one of the horizontal tapes right from the beginning of the fastex loop.