How to make Distance Measurement device | Step by Step Tutorial |
Hey guys,
In this video i am going to show you how to make an Ultrasonic distance measurement device.I have given step by step tutoria for this project.
Feel free to ask any questions.
Things you will need-
Arduino uno- https://amzn.to/36TJqcg
Ultrasonic Sensor (HR-SR04)- https://amzn.to/2Tkzc0B
Lcd Disply 16x2- https://amzn.to/2FNYtIN
10k ohm Potentiometer- https://amzn.to/3843HMB
Jumper Wires- https://amzn.to/2TmNHRx
Breadboard- https://amzn.to/30h96gw
Do not forget to Like, Share & Comment on the video.
--------------------------------------------------
Lcd Connections-
PIN No-
1. VSS - GND
2. VDD/VCC - +5V
3. Vo/VEE - Center pin of 10k potentiometer
4. RS - DIGITAL PIN 1
5. RW - GND
6. ENABLE - DIGITAL PIN 2
11. D4 - DIGITAL PIN 4
12. D5 - DIGITAL PIN 5
13. D6 - DIGITAL PIN 6
14. D7 - DIGITAL PIN 7
15. (LED +) - +5V
16. (LED - ) - GND
Ultrasonic Sensor (HC-SR04) Connections-
1.Connect the GND pin of ultrasonic sensor to gnd pin of arduino
2.Connect Echo pin to Digital pin 10
3.Connect Trig pin to Digital pin 9
4.Connect Vcc pin to +5v pin of arduino which was connected to breadboard
--------------------------------------------------
Links mentioned in videos-
circuit diagram- https://bit.ly/35PhPHY
arduino ide -https://bit.ly/2kdak6c
Code-https://bit.ly/3a5LK1M
--------------------------------------------------
Jarico - Island
/ jaricomusic
Vlog No Copyright Music: • Video
--------------------------------------------------
Follow Makermate! on-
Instagram-https://www.instagram.com/hatim__0/?h...