Removing broken exhaust studs, in aluminum head.

How can we open this?

What could possible be making this noise?

70’s C20 350 V8 dually. First start in 15 years, just after overhauling the carburetor.

Confused Ford Ranger

Just Because it’s Funny

Getting The Alternator Shims Ready For Install Before Removing it.

Closing Alternator Spacers The Easy Way.

Removing broken exhaust studs, in aluminum head.

How To Chase Threads Without a T Handle.

Restoring plastic trim with a propane torch. Amazing!

Easiest Way to Remove a Fan Clutch!

Heating a Harmonic Balancer to Install Does Not Hurt The Seal!!

Installing Shift Linkage Bushings The Easy Way.

Easy way to line up a non studed transfer case and gasket.

Harmonic balancer install without tools, using only a MAP Gas torch.

Removing a Stuck Brake Rotor.

How To Get A Stuck Brake Rotor Off.

347 EFI Installed in a 65 F-100 Short Box.

Loosening the crank bolt on a 5.3 without the special service tool.

How to loosen a GM 5.3 crankshaft pulley (Harmonic balancer) bolt without the special service tool.

When To Buy A Salvage Vehicle….NEVER!

The dealer wanted to charge 6500 for blown fuses! Ford Fusion overheating because fan not working.

Does your Chrysler start, run for 3 seconds and die. It has no alarm but sure acts like it?

If your 1999-2009 F-350 has DTC P0750, P0755, P0743 and P1753, check this after you check the fuse