DIY Honda Genio Knuckle Bearing Installation
DIY Honda Genio Knuckle bearing Installation Guide
#Honda #Genio #HondaGenio #Scooter #HondaMotorcycle #DIY #knuckle #bearing
0:00 Introduction
0:26 remove headlight assembly
0:42 remove front wheel
1:06 remove front fender
1:15 remove front brake assembly
1:27 remove side fairing & rack
1:58 remove steering bar
2:06 remove T-post nut
2:13 remove old upper & lower ball race
2:23 apply grease & install upper ball-race
2:48 apply grease & install lower ball-race
2:58 use the old ball-race to fit the new ball race
3:29 remove old ball-race
4:16 clean to remove dirt & old grease
4:43 install new ball-race
5:38 install T-post
5:48 lock the T-post using its nut
5:54 dont forget the washer
6:07 lock nut, then tighten
6:16 install back the steering bar
6:24 lock the steering bar using its bolt
6:33 check stiffness of the steering
6:39 assemble it back :D