Sovol SV01 PTFE Insert and Z Axis Limit Switch Setup
Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate...
SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/
---
Here are two essential steps to setting up your Sovol SV01 right: PTFE (Capircorn Tubing) insert in the extruder will let you print flexible filament like TPU without it spiraling up inside the extruder; correct Z axis limit switch will give stable and repeatable bed level.
-- PRODUCT LINKS --
I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.
The Capricorn Tubing (PTFE Tubing) that I used (comes with cutter!) is:
Amazon - https://amzn.to/35CtDhG
Buy the Sovol SV01 at:
Amazon - https://amzn.to/33Q2O7F
Sovol - http://bit.ly/2DRp6eY
MANDATORY DISCLAIMER: I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn fees by linking to Amazon.com and affiliated sites.
Most or all links above are affiliate links, and I will receive compensation if you use them.