H2 Vision Therapy Instructions
The H2 Vision Therapy kit includes the following components:
OCU-ION device
Heating iontophoresis tube
Transparent cover
Upper transparent cover
Eye mask
Power cable
Heating iontophoresis cable
Restore Vision Hydrogen Tablets
Important Safety Note: H2 Vision Therapy should be conducted in a well-ventilated area. Open flames such as lighters and smoking are strictly prohibited, and avoid using the device in direct sunlight to prevent overheating or malfunction.
Using Restore Vision Hydrogen Tablets:
1. Add approximately 150 ml of regular drinking or purified water at room temperature until it reaches the blue fill line inside the water tank. Make sure the water level is at the blue mark, as filling below or above this line can hinder fog production.
2. When pouring water into the tank, be sure to avoid getting any water in the air outlet, as this can damage the internal components of the device.
3. The Restore Vision Hydrogen Tablet is made of porcelain and is not water-soluble. It remains undissolved during treatment and maintains its original size. When soaked in water, a single tablet releases hydrogen gas for 3 hours, with the highest concentration reached after at least 30 minutes.
4. For each use, soak one tablet in the water tank of the OCU-ION device. Ensure the tablet is placed in the designated blank space without covering the ultrasonic atomization outlet; if the tablet obstructs the outlet, fog production will be prevented.
5. Allow the tablet to soak in the water for at least 30 minutes to achieve the highest concentration of hydrogen gas before turning on the machine.
6. Keep your eyes open throughout the entire treatment session. Do not open the transparent cover while the device is in operation, as this may allow water to flow into the air outlet.
7. During treatment, keep the hydrogen tablet submerged in the water. After each session, remove the tablet and water, and wipe the inside of the water tank with a dry towel. Always ensure the device is clean and dry after each use.
Control Panel:
There are four touch buttons on the touch screen:
1. Heat Fog (+-): Adjusts the fog temperature. Press this button to choose warm or cold fog. We recommend adjusting it based on the season: warm fog in autumn/winter, and cold fog in summer/spring.
2. Timer: Set the duration for 15 or 20 minutes. The device will stop automatically when the selected time is up.
3. Vol. (+-): Controls the fog volume. Adjust to a comfortable level for your preference. The higher the volume setting, the greater the amount of hydrogen gas released.
4. ON/OFF: Press to turn the machine on or off.
----------------------------------------------------------------
For more information about H2 vision, please check:
https://www.restorevisionherbs.com/h2...
Contact us for any question:
[email protected]