Sovol SV08 X End Stop, Klicky & nozzle LED Install
After the First Video when we have presented the Shroud V3 and all the benefits that it had with over 230 download on Printables we had a lot of questions on how to connect all the cables. how to klicky works and a lot of other questions + a lot of people has complained that the first video that it was a live stream it was too long to watch so i have dismantle the 3d printer, it took me more than 10 hours, to make this video I will apricate a like. hope that with this video I have answered all the questions. if you have any other questions please leave them in the comments.
Here is an aff link if you consider buying a Sovol sv08 http://shrsl.com/4tva2 no additional cost for you and you will support us to develop new upgrades 🙏
where you can download the parts? here you will find also all the firmware part that you need to add/delete in the printer.cfg
https://www.printables.com/model/9387...
Support the Channel:
Love 3D printing? Explore Polymaker's incredible range of filaments and materials! Use our affiliate link to shop: https://cn3dp.short.gy/polymaker . You'll unlock access to all available coupon codes, pay nothing extra, and help us create more content and make upgrades. Thanks for your support!
Toolhead Board FAN
[controller_fan extra_controller_fan]
pin: extra_mcu:PB0
fan_speed: 0.5
The fan speed (expressed as a value from 0.0 to 1.0) that the fan
will be set to when a heater or stepper driver is active.
The default is 1.0
idle_timeout: 60
The amount of time (in seconds) after a stepper driver or heater
was active and the fan should be kept running. The default
is 30 seconds.
idle_speed: 0.3
The fan speed (expressed as a value from 0.0 to 1.0) that the fan
will be set to when a heater or stepper driver was active and
before the idle_timeout is reached. The default is fan_speed.
heater: extruder
read the full description on printables to update all the firmware in the printer.cfg