Building a Wireless Corne with Lubed and Filmed Alpacas
I finally took the dive into a 3x5 layout board. This one uses Nice!Nano V2.0's and has 500 mah batteries which will give about a month of use on a single charge. The case I designed myself and did some stuff to make it sound a lot better as a 3D print.
~ Links ~
Poron Switch Pads: https://amzn.to/3CX9AxW
Batteries: https://amzn.to/3RcWssP
Case: https://scottokeebs.com/products/scot...
Cases, Keyboards, and Keycaps: http://scottokeebs.com
~ Timestamps ~
0:00 - Case Printing
2:10 - Prototypes
4:58 - Switches and Case
6:23 - Prepping Switches
6:52 - PCBs Arrive
7:43 - Soldering
8:21 - Meme
9:42 - Typing Test
10:48 - Outro
~ Social ~
/ joe_scotto
/ joe_scotto
https://ko-fi.com/joe_scotto
~ Disclaimer ~
Some links may be affiliate links where I will make a small commission. Nothing in this video was sponsored by any outside party and I wasn't paid for the content in this video.