COEX Clover 4.2 Drone Kit Assembly & Configuration
00:00 Unboxing
03:10 Frame Assembly
07:54 Installing Motors
11:31 Installing Electronic Speed Controller (ESC)
12:27 Frame Preparation for FC & RPi
14:28 Installing Power Distribution Board (PDB)
15:34 Installing Flight Controller
16:22 Connecting Flight Controller
17:33 Installing GPS
18:26 Mounting Deck for Raspberry Pi
20:02 Heat Sink for Raspberry Pi
20:16 Installing Raspberry Pi
21:39 Radio Receiver
22:01 Laser Rangefinder
22:14 Camera
23:35 Connecting to Raspberry Pi
24:36 Install LED Strip
26:11 Install Legs
29:23 Install Guard
34:51 Connect Radio Receiver to Flight Controller
35:37 Connect Flight Controller to Raspberry Pi
36:09 Charging Battery
36:29 Voltage Tester
36:38 Battery Strap
37:04 Install Battery
37:30 Format MicroSD Card
37:48 Flashing Flight Controller
38:38 Insert Flashed MicroSD Card into Flight Controller
38:49 Connect Flight Controller to QGroundControl software with USB
39:10 Setting Airframe
39:39 Parameters View
39:55 Setting Autopilot Orientation Columns
40:09 Sensor Calibration: Compass, Gyrospoce, Accelerometer & Level Horizon
41:16 Transmitter Calibration
42:04 Power Setup & ESC Calibration
42:58 Flashing Clover v0.22 RPi Image
43:18 Insert MicroSD Card into Raspberry Pi
43:28 Raspberry Pi Network Connection
43:41 Raspberry Pi Camera View
43:46 SSH Raspberry Pi Remote Access
43:52 Automated Self-check
44:01 Autonomous Flight Test - flight.py
44:12 Install Propellers
45:00 Flight Test
45:26 Simulate COEX Clover by running flight.py at Gazebo
46:45 End
#COEX #Clover #Gazebo #Python #Simulation #Drone #UAV #Moopt