Server PSU Hack - HP DPS-800GB A, 12VDC 1000W
A guide on how to make the, HP DPS-800GB Rev. A, server power supply run outside of its server enclosure. A simple bridge between pin 31 and 34 is required and it is important to NOT drill holes through the GND and +12VDC output pads, this will risk short-circuiting the output as its a 4-layer PCB.
Discussion and schematic: https://highvoltageforum.net/index.ph...
↝↝ Additional information and links ↜↜
★ Partners: @arcattackmusic and @franzolielectronics
★ Music by Mikas: / mikasdk (used with commercial permission)
★ T-Shirts, mugs and other merchandise: https://teespring.com/stores/kaizer-p...
★ Electronics website: https://kaizerpowerelectronics.dk
★ Facebook: / kpedk
★ High Voltage Forum: https://highvoltageforum.net
★ My Slow motion videos channel: / @slowmotionvideosdk
★ Find me at Odysee: https://odysee.com/@KaizerPowerElectr... and https://odysee.com/@SlowMotionVideos:5
★ Find me at LBRY: https://lbry.tv/@KaizerPowerElectroni...
$ For commercial/non-commercial licensing of material, contact through here: http://kaizerpowerelectronics.dk/abou...
♥ Donations
Please consider one of the following:
♥ Donate via Paypal: [email protected]
♥ Donate crypto currency directly on these addresses (Check if there is minimums before transfer):
• Bitcoin: 36gKDS4PfmPdmi2YC9kRASNV9Au8rUXbBS
• Litecoin (old): 3MHsQ1xhPvoqUv51dXJHAHZf2QXLZ7UEbo
• Litecoin (new): MTW1huNfM3fGHRLujQHcyvp4M77nYpLTGF
#electronicscreators #server #psu #diy