Configure CDP, LLDP, and NTP Example - Network Management - Lab 10.8.1 - CCNA - KevTechify | vid 86
In this episode we are going to look at configuring Configure CDP, LLDP, and NTP.
A network administrator has been asked to investigate a new client’s network. Documentation is incomplete for the network, so some information needs to be discovered. In addition, the NTP server needs to be configured on a router. Discovery protocols must also be adjusted to control traffic discovery protocol traffic and prevent information about the network from being received by potentially unauthorized hosts.
Some of the device IP addresses are unknown to us. We must determine what the IP addresses are so that we can connect to the devices over SSH in order to configure them. We can enter them into the Addressing Table as you discover them.
In this activity, we will configure a router to receive time information over NTP and configure devices with CDP and LLDP. Configure CDP to run globally on a device. Disable CDP on device interfaces where necessary. Configure LLDP to run globally on a device., Configure LLDP to send and receive messages according to requirements. Configure a router to use an NTP server.
Thank you so much for watching this episode of my series on Configuration Examples for the Cisco Certified Network Associate (CCNA).
Once again, I’m Kevin and this is KevTechify. Let’s get this adventure started.
All my details and contact information can be found on my website, https://KevTechify.com
YouTube Channel: / kevtechify
-------------------------------------------------------
Cisco Certified Network Associate (CCNA)
Enterprise Networking, Security, and Automation v3 (ENSA)
Network Management
Packet Tracer Lab 10.8.1 - Configure CDP, LLDP, and NTP
Lab Number: 86
-------------------------------------------------------
Equipment I like.
Home Lab ►► https://kit.co/KevTechify/home-lab
Networking Tools ►► https://kit.co/KevTechify/networking-...
Studio Equipment ►► https://kit.co/KevTechify/studio-equi...